Ega Master 79602 Manual De Instrucciones página 28

Disassembly and assembly should only be performed with the assistance of the sectional
drawing.
All parts can be dismantled by light pushing or knocking (wooden base / rubber hammer).
Motor
Clamp the machine at the gearbox housing item 40 into the vice. Use plastic jaws that enclose
the gearbox housing as far as possible and unscrew the housing item 1. Pull out the motor. Open
the motor on the toothed side for changing the vanes item 8, the front end plate item 9, the cylinder
bushing item 6 or the grooved ball bearings items 3 and 11. This will be done by holding the motor
on the cylinder bushing and knocking the toothed side of the rotor item 7 against a wooden base.
During installation of new vanes take care that the vanes do not jut out of the rotor.
Gearbox 79602/79603
Attention! The planetary gear can be completely removed from the gearbox housing. Lever up
the three-jaw chuck item 100 with the help of two levers (or special tool) from the planet carrier
output shaft. Lightly knock the edge of the gearbox housing (on the thread) on a wooden base. The
gearbox comes off and can be drawn out of the housing easily. Grease the gearbox at
re-assembly.
Gearbox 79604
Screw off the three-jaw chuck item 100 from the output shaft item 113.
Remove the additional handle. Knock the gearbox housing item 40 with the inner thread side
lightly on a wooden base. The gearbox stages come off and can be drawn out of the housing easily.
Remove snap rings items 44 and 126 and pull out bearing ring item 110 with bearings. At this
light pushing or knocking on a wooden base could be helpful. Clamp the gearbox housing and turn
the bushing with adjusting ring items 129, 128 left-hand till to the stop. To screw off the bushing
from the adjusting ring warm up the bushing with a hot air blower before. Remove steel rollers item
127. Remove snap ring item 123 and draw out the complete output shaft item 113. If necessary,
continue to disassemble.
28
Transparent oiler
For installing in permanently equipped workplaces.
(Especially for type using service units – see accessories list)
The transparent supply containers allow for good checking
as well as for good setting possibility by means of a
screw driver via a set screw with a visible dripping.
(The set screw is above the lateral thread connection
– turning to the right for less oil; turning to the left
for more oil). The setting (2 to 5 drops per m
consumption) is to be carried out when air is flowing
through, i.e., when the machine is running.
DISASSEMBLY
/min air
3