Qlima FPG 102 Instrucciones De Uso página 25

CLEANING
"Burning off" the barbecue after every use (for approx 15 minutes) will keep excessive food
residue to a minimum.
OUTSIDE SURFACE
Use mild detergent or baking soda and hot water solution. Non-abrasive scouring powder can
be used on stubborn stains, then rinse with water.
If the inside surface of the barbecue lid has the appearance of pealing paint, baked on gre-
ase build up has turned to carbon and is flaking off. Clean thoroughly with strong hot soapy
water solution. Rinse with water and allow to completely dry. NEVER USE OVEN CLEANER
INTERIOR OF BARBECUE BOTTOM
Remove residue using brush, scraper and/or cleaning pad then wash with a soapy water solu-
tion. Rinse with water and allow dry it.
PLASTIC SURFACES
Wash with a soft cloth and hot soapy water solution. Rinse with water. Do not use abrasive
cleaners, degreasers or a concentrated barbecue cleaner on plastic parts.
COOKING GRID
Use a mild soapy water solution. Non-abrasive scouring powder can be used on stubborn stains
then rinse with water.
GREASE TRAY AND GREASE CUP
Please do not open the grease tray during use.
When clean the grease tray, take away the grease cup first then pull out the grease tray.
Please check the grease cup on time and take away the oil when 1/3 full.
Method: after the grease cup cold, make grease cup up in horizontal line and move it with
hook reverse horizontally, this could take out the grease cup.
CLEANING THE BURNER ASSEMBLY
Turn the gas OFF at the control knob and disconnect the cylinder.
Remove cooling grate.
Clean the burner with a soft brush or blow clean with compressed air and wipe with a cloth.
Clean any clogged ports with a pipe cleaner or stiff wire (such as an opened paper clip).
Inspect burner for any damage (cracks or holes). If damage is found, replace with a new bur-
ner. Reinstall the burner, check to ensure that the Gas valve orifices are correctly positioned
and secured inside the burner inlet (venturi).
In some cases your barbecue will light back because of an insect crawling inside the burner
venturi or a spider spinning its web inside the burner. This can be rectified by using a bot-
tle brush inserted through the burner venturi and pushing it into the burner over the burner
length. If condition persists consult your gas dealer.
4
25