Publicidad
Idiomas disponibles
Idiomas disponibles
[o_o)_l
TO REMOVE SNOW FROM AUGER
A
ARNING: Do not attempt
to remove snow or debris
that may become lodged in
auger with your hands. Use the
cleaning stick to remove snow or
debris.
A cleaning stick is attached to the top of
the auger housing.
Use the cleaning
stick to remove snow from the auger
housing.
•
Release auger drive lever.
•
Remove (do not turn) safety key.
•
Disconnect spark plug wire.
•
Do not place your hands in the au-
ger or discharge chute. Use the
cleaning stick to remove snow.
SNOW
THROWING
TIPS
1.
For maximum
snow
thrower
efficien-
cy in removing
snow, adjust ground
speed.
Go slower
in deep, freezing
or wet snow.
If the wheels
slips, re-
duce forward
speed.
2.
Most efficient
snow
throwing
is ac-
complished
when the snow
is re-
moved
immediately
after if falls.
3.
For complete
snow
removal,
slightly
overlap
each path previously
taken.
4.
The snow
should
be discharged
down wind whenever
possible.
5.
For normal
usage,
set the skids so
that the scraper
bar is 1/8" above
the skids.
For extremely
hard-
packed
snow surfaces,
adjust the
skids upward
so that the scraper
bar touches
the ground.
6.
On gravel
or crushed
rock surfaces,
8.
9.
set the skids at 1-1/4" below the
scraper bar. See To Adjust
Skid
Height paragraph in the Service &
Adjustments
section of this manu-
al. Rocks and gravel must not be
picked up and thrown by the ma-
chine.
After the snow throwing job has
been completed, allow the engine to
idle for a few minutes, which will
melt snow and accumulated
ice off
the engine.
Clean the snow thrower thoroughly
after each use.
Remove ice and snow accumulation
and all debris from the entire snow
thrower, and flush with water (if pos-
sible) to remove all salt or other
chemicals.
Wipe snow thrower dry.
F 0410108L
17
Publicidad
