Maintenance; Troubleshooting - Armor All AA6BP2 Manual Del Usuario

CAUTION: Ensure your orbital polisher is disconnected from any power supply before performing any
maintenance on it.
Proper maintenance is important in getting the longest life and best results from your Armor All
polisher. Follow the below steps to keep your tool in good working order:
1. Wipe the polisher clean. Use a damp cloth and wipe the surfaces and cord clean after use. Mild soap
can be used if necessary. Do not get water in the vent openings, as it can cause electrical issues and
corrode internal parts.
2. Care for the buffing wheel. Remove excess wax or polish from the buffing wheel before storing. Store
the orbital polisher on its side to avoid compressing the buffing wheel.
3. Clean the bonnets. Bonnets may be hand or machine washed (gentle cycle - do not use fabric
softener). Air dry before storing. Do not let bonnets air dry on the polisher, as it will stretch the elastic
band permanently and prevent the bonnet from fitting snugly.
4. Replace worn bonnets. Replacements can be found at your local hardware or automotive retailer.
5. Store the polisher with the base pad up to avoid shape change from prolonged compression.
6. Do not attempt any electrical repairs. Repairs should be conducted by a qualified service
professional.
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE TROUBLESHOOTING
Symptom
Uneven wax distribution
Difficulty polishing
Buffing wheel doesn't
spin or does so slowly
Orbital polisher won't turn
on
Bonnet has a wrinkle or
a crease that is causing
uneven buffing or
polishing

MAINTENANCE

TROUBLESHOOTING

Possible Causes
1) There is excessive polish/wax on
the bonnet.
1) The bonnet is worn.
1) Motor needs to be serviced or
replaced
1) There is a bad connection to the
power outlet.
2) There is a problem with the motor.
1) The elastic band or drawstring is
not tight.
1) Remove some of the polish or
wax and try again.
1) Replace bonnet.
1) Take your orbital polisher to a
qualified service center.
1) Check extension cord gauge and
connection to outlet.
2) Take your orbital polisher to a
qualified service center.
1) Untie the drawstring and re-
tighten. In case of elastic, replace
the bonnet.
12
Corrective Action
®
orbital