BLACK&DECKER BDH-D16 Guia De Inicio Rapido página 6

Safety Protection Systems
• This product has protection safeguards that shut off the product when parts become excessively hot or
if it tips over. If the product shuts off, immediately turn the Control to the "O" position and unplug it
from the electric outlet.
• If overheated:
a. Remove any objects near the product that may cause overheating. Use the product
b. Allow the product to cool down for at least 10 minutes before plugging it back into
• If tipped over place the product on a flat, level, stable surface in order to prevent the product
from tipping over again.
Care And Maintenance
WARNING: Do not attempt to disassemble this product for any reason, as incorrect
WARNING: Always unplug the product from the electrical outlet and allow it to cool before cleaning or
WARNING: Do not allow water or other liquids to enter the interior of the product.
NOTICE:
NOTICE:
in a well-ventilated area. Keep at least 3 feet (0.9 meters) of space on all sides
of the product to allow adequate air circulation.
an electric outlet for re-use.
re-assembly could cause a risk of fire or electric shock. Only qualified service personnel should
perform any servicing.
storing it.
This product is permanently lubricated at the factory before shipping and will not require
further lubrication for the life of the product.
Clean only the exterior surface by wiping with a soft, damp cloth, and allow the product to dry
completely before storing or using. Dust can be removed from any vents using a small vacuum.
Do not use abrasive cleaners/pads to clean the product.
To store, wind and secure the power cord using a twist tie or rubber band, and then place the
product in a cool, dry location.
6