Horizon Global 36110 Instrucciones De Instalación página 5

n
2. Install hitch – Using the supplied pullwires install the carriage bolts ①and spacers ② into the vehicle frame through the access hole, see Fig. 2, leave
pullwires attached. Raise the hitch into position and align holes in hitch bracket to the carriage bolts installed, guiding the pullwire ends through holes in the hitch
l m
bracket. Remove pullwires, install conical washers (teeth side toward hitch) and nuts , see Figure 1.
3. Tighten all 7/16 - 14 " fasteners with torque wrench to 50 Ft.Lb. (68 N*M)
⑤
Kink pullwire to keep spacer independent of
bolt
Figure 2
Proper torque is needed to keep the hitch secure to the vehicle when towing.
©2020 Horizon Global™ Corp - Printed in Mexico Sheet 5 of 18 36110NP 3-4-20 Rev. B