Kohler K-1457-CT Diagrama De Instalación página 2

NOTE: Pump/piping protrudes beyond rim.
2" (5.1 cm)
Product Information
Applicable product:
Bath whirlpool with relax package
Fixture*:
Bathing well:
Basin area bottom 50" (127 cm) x 29" (73.7 cm)
Basin area top 61" (154.9 cm) x 32" (81.3 cm)
Weight 130 lbs (59 kg)
To overflow:
Water depth 16" (40.6 cm)
Capacity 100 gal (378.5 L)
* Approximate measurements for comparison only.
Included component:
Cut-out template
kW
Pump
Heater 1.5
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Pump/control 220-240 V, 20 A, 50/60 Hz
1023226-1-D
3" (7.6 cm) x 24" (61 cm)
Flat Faucet Deck
42" (106.7 cm)
Pump/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H Min
1-1/2" OD
K-1457-CT
113311-7
V Hz
240 50/60
240 50/60
2-1/2"
(6.4 cm)
Locate the outlet behind the whirlpool and within 24"
(61 cm) of the pump.
Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of 51
lbs/square foot (247.3 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim-mount faucet, make sure there is no interference
with drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions are
nominal.
A
11
11
2
No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF)
Recommended faucet area.
5-1/4"
(13.3 cm)
6-1/2"
33-1/2"
(16.5 cm)
(85.1 cm)
67" (170.2 cm)
3" (7.6 cm)
2-7/8" (7.3 cm)
13-1/2"
(34.3 cm)
3-1/2"
(8.9 cm)
22"
(55.9 cm)
Kohler Co.