Safety Instructions - hjh OFFICE VM-MG1 Manual De Instrucciones

4
EN
ENGLISH
Introduction
Thank you for purchasing a hjh OFFICE product.
Please read the following instructions carefully.
Illustrations may slightly differ from the actual execution.
For reasons of clarity, not all conceivable assembly variants can be described.
If you need more information and help, please contact us:
Tel .: +44 (0) 203 318 5230
email: service@hjh-office.co.uk
Note
First unpack all parts of the delivery and check them for possible transport damage.
Damaged or missing parts can affect the safety and function. In this case please contact us first before
proceeding with the installation.
In order to ensure an easy construction, we recommend at first to tighten all screws only partially.
Only after all screws have been inserted into their respective thread, should they be tightened.

Safety instructions

1. Prior to the installation of this product, the installation instruction must be read and completely understood.
Failure to do so may result in personal injury, property damage or voiding of factory warranty.
2. Do not install on a structure that is prone to vibration, movement or chance of impact.
Reinforce the structure as required before installation.
3. The desk clamp can support a maximum thickness of 9 cm. Confirm the desk edge before installation.
4. Pay attention to the weight capacity of the mount (8 kg). Exceeding the limitation can result in function
unworkable or even serious personal injury and property damage.
5. Never operate the mount if parts are missing or damaged. Contact your local service center for warranty service.
Assembly
1. Lift the spring arm along with the monitor and put it on the extension arm. Insert the screw through the hole
from extension arm to decorative cap.
2. Use a hex wrench to adjust the height tension of the gas spring arm, to keep different weight of monitors still
at any position.
Note: Turn clockwise to reduce tension for lighter monitors and counter-clockwise to increase tension for heavier monitors
3. Use a hex wrench to adjust the damp for swiveling. Turn counter-clockwise to reduce damping and clockwise
to increase damping.
4. Insert cables into cable covers. Use cable clamp to limit cables close to steel pipe.