Publicidad
Idiomas disponibles
Idiomas disponibles
Installation to Wood Stud Wall
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is ¿ rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud ¿ nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-
ers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).
Wall plate (A) can be mounted to two studs that are 16" apart. Use a stud ¿ nder to locate the edges of the studs.
1
Use of an edge-to-edge stud ¿ nder is highly recommended. Based on their edges, draw a vertical line down each
stud's center. Place wall plate on wall as a template. The top mounting slots should be located at your desired
display center. Level plate, and mark the center of the eight mounting holes. Make sure that the mounting holes
are on the stud centerlines. Drill eight 3/16" (5mm) dia. holes 3" (76mm) deep. Make sure that the wall plate is
level, secure it using eight 5/16 x 3" wood screws (O) and washers (P).
Skip to step 2
WARNING
• Never mount this product to metal studs without the
required accessory.
A
P
O
WARNING
5 of 41
ISSUED: 06-05-06 SHEET #: 202-9141-9 04-30-11
Publicidad
