Jacob Jensen Temperature Station Manual Del Usuario página 20

maintenance
The following guidelines will help you care for the JACOB JENSEN
Temperature Station so you can enjoy using it for many years.
1. Keep the temperature station dry at all times. If it becomes wet, wipe
it dry immediately. Liquids can contain minerals that might corrode the
electronic circuits.
2. Use and store the temperature station only under normal temperatures.
Temperature extremes can shorten the life of electronic components,
damage batteries and distort or melt plastic parts.
. Handle the temperature station and sensor(s) gently and with care.
If they are dropped, circuit boards can be damaged, resulting in
malfunction.
4. Keep the temperature station free from dust and dirt, to avoid the
premature wear of parts.
5. Clean the temperature station by wiping with a soft cloth. Do not use
aggressive chemicals, cleaning solvents or strong detergents to clean the
temperature station or sensor(s).
6. Use only fresh batteries of the required size and type. Always remove
old or weak batteries as they might leak chemicals that will destroy the
product.
7. Modifying or tampering with the internal components of the
temperature station or sensor(s) may cause malfunction and will
invalidate the warranty.
specifications
Operating temperature
Operating temperature - sensor : -20°C to 60°C (-4°F to 140°F)
RF Transmission Frequency
Maximum no. of sensors
Power source
Dimensions
Weight
Dimensions - sensor
Weight - sensor
20
: 0°C to 50°C (2°F to 122°F)
: 4 MHz
: 
: 2 UM-4 or "AAA" size batteries each for
the temperature station and the sensor.
: 140 x 62 x 22 mm
: 110 g
: 52 x 140 x 22 mm
: 126 g
Disposal
This appliance is labelled in accordance with European directive 2002/96/EG
TM
concerning used electrical and electronic appliances (waste electrical and
electronic equipment - WEEE). The guideline determines the framework for
the return and recycling of used appliances as applicable throughout the
EU. Please ask your dealer about current means of disposal.
- The contents of this manual are subject to change without notice.
- The manufacturer and its suppliers accept no liability whatsoever for any
damage, expense, loss of profits or any other damage incurred as a result
of using this product.
This device complies with the essential requirements of Article  of the R&TTE 1999/5/EC Directive, if
used for its intended use and that the following standards has been applied:
Electromagnetic compatibility (Article .1.b of the R&TTE Directive)
Applied standards:
Efficient use of the radio frequency spectrum (Article .2 of the R&TTE Directive)
Applied standards:
r&TTe Compliance note
ETS 00 68 :1997
EN00 220 –1 :1997
intended use of the device