Monitor Installation - Beeper RW7 Instalación Y Uso

MONITOR INSTALLATION

Thanks to its rotating bracket and sticker, RW7 monitor can be placed anywhere in your vehicle.
The ideal position of your monitor is on the top of car roof near rearview mirror. If this position
is not possible or not appropriate, you can set the monitor on the dashboard so visible during
reversing. Make sure that the monitor is not too visible from outside the vehicle so as not to
attract thieves.
The screen is fixed by an adhesive on a backing high strength double-sided. We advise you to
clean and degrease the surface before bonding.
We recommend the use of a primary (our ref: RX-PR01 not supplied in this kit) allows maximum
adhesion before bonding double-sided. The primary must be applied on both parts receiving the sticker : monitor bracket + dashboard or rooftop
part where the bracket will be stuck.
When you put the screen on the headlining, it is recommended to screw the support thanks to the holes provided.
The rotating bracket allows you to use your screen in all directions, just rotate the image using the bottom button on the right side of the screen.
The wiring must be concealed in the amounts of windshield under the dashboard, under the trim and must not be apparent. There must not interfere
with the driver operation, put it away from heating elements.
19
181 mm
178 mm 178 mm
161 mm
120 mm
121 mm