Wireless Remote Control; Replacing The Fuse - Beamz Rage 600 Manual De Instrucciones

OPERATION
Connect the power lead into the fog machine and earthed mains outlet. Then you can switch the power on by
ON/OFF switch.
After a certain warm-up time, the fog machine is ready to operate. Then the stand-by LED of the remote control
lights up. By operating the smoke switch on the remote control the smoke emission starts. It may happen that
the stand-by lamp turns off and the smoke emission stops. In this case the device is heating up again and will
be ready to operate again.
Switch off when fog machine not used and unplug from mains if not use for long periods.

WIRELESS REMOTE CONTROL

The wireless remote control have 4 buttons. Press one of the buttons (A,B,C or D) and the smoke machine will
produce fog as long as you press the button.
CLEANING
The fog machine must be cleaned to avoid deposits in the machine, pump and heater.
Procedure:
1. Remove smoke fluid from the tank, fill "Beamz smoke machine cleaner fluid" (item no. 160.670) into empty tank.
2. Switch the power on and wait until smoke machine is warmed up.
3. Press on the button of remote control and pump the liquid through the machine.
4. Perform the above operation until the tank is empty.
5. Fill the tank with Beamz smoke fluid.

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
ACCESSORIES
High quality smoke fluid on water basis, specially designed for Beamz smoke machines guarantees a trouble-free use.
5 liter packaging, ref. no. 160.582
1 liter packaging, ref. no. 160.643
Do not allow the pump to run dry!
(ONLY BY 160.702 / 160.704 / 160.710)
Run clean procedure in a well-ventilated area!
5