WINTAIR AW-10CR1FM Manual De Uso Y Mantenimiento página 15

Youcan
easily operate this air conditioner by pressing
relevant button on the control panel as well as the
remote control
ON/OFF Button
The air conditioner will be started when it is energized
or will be stopped when it is in operation, if you press
this button.
Mode button
Each time Mode button is pressed, the operation
mode is changed in sequence:
COOLING FAN ONLY ENERGY SAVING COOLING
f
Mode:
eoeling (with fan speed Lo, Med, High): Compressor
cycles to maintain Temperature Set Point. Fan remains
on at selected speed during compressor OFF cycle.
Cooling (Auto Fan Speed): Compressor cycles to maintain
Temperature Set Point. Fan speed is controlled from room
temperature. Fan remains on during compressor OFF cycle.
Fan Only: Circulates and filters room air at selected speed.
Energy Saving (with fan speed Lo, Med, High):
Fan cycles ON and OFF with compressor over a wider
range of temperatures.
Energy Saving (with Auto Fan Speed): Fan cycles ON and
OFF with compressor at a wider range of temperatures. Fan
speed during ON cycle is dependent on room temperature.
Control Panel
_Jk
FAN .....................................
[T_ME_ j
i MoeEi
Indication symbols of LED on control panel:
Auto fan speed _ Cooling
_3 I'F
IHR
Low fan speed _% Fan only
Display set temp
Display set timer
i_ Medium fan speed C) Timer
High fan speed -(3: Energy-saving
LED on control panel lights on when the relevant mode is in used.
NOTE: After setting the mode, allow three (3) minutes before switching to another mode. In the FAN ONLY Mode,
Room Temperature display range is from 0°C (32°F) to 38°C (99°F). Room Temperature below 32°F, the
Temperature display LO. Room Temperature above 99°F, the Temperature display H1.
Fan Speed Button: Used to select fan speed in sequence auto, low, medium, and high.
High Highest fan speed for maximum cooling
Medium Normal fan speed for average cooling
Low Lowest and quietest speed, greater dehumidification
Auto Works in Cooling and Energy-Saving mode to vary fan speed based on room temperature.
Timer Button: Used to set or cancel timer operation.
When the unit is in operation, you can set OFF TIMER. When the unit is OFF, you can set ON TIMER. Timer
setting range is 0 to 24 hours.
If the OFF TIMER is set, the time LED displays the remaining time to turn off the unit for only 12 seconds,
then LED shifts to display set temperature. If you press TIMER button within the 12 seconds, OFF TIMER
will be cancelled.
If the ON TIMER is set, the timer LED displays the remaining time to turn on the unit. If you want to
cancel ON TIMER, press TIMER button.
A V Button
Used to set room temperature in COOLING mode or used to set time in TIMER mode.
NOTE: Temperature setting range is from 19°C (66°F) to 31 °C (88°F).