Fellowes POWERSHRED DS-1 Manual Del Usuario página 5

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
5-minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Plug in and put
Continuous operation beyond
disconnect power
4-5-minutes will trigger
ADVANCED PRODUCT FEATURES
SAFESENSE TECHNOLOGY OPERATION
®
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1 1
2
Touch test area and
Turn the shredder ON
look for the SafeSense
( ) to activate
indicator to illuminate
SafeSense
®
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature
and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery
time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
PAPER JAM
1 1 1 2
Press and hold Reverse
Alternate slowly back and forth
(R) 2-3 seconds
1 2
3
Press Auto-On ( ) Check paper amount
3
SafeSense is active
®
and working properly
®
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 1
Set to Off
1 3 1 4
Set to Off
and unplug
4
Feed paper straight into
paper entry and release
1 3
2 3
Press and hold Reverse
*Apply oil
across entry (R) 2-3 seconds
1 6
5
Gently pull uncut paper
Press and hold
from paper entry. Plug in. Reverse (R)
5
1 6
or
Feed into center of When finished
entry and release shredding set to OFF
3