Assembly; Operation - Speed Clean 2800PSI Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY

IMPORTANT: Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
Carton
1.
Remove the parts bag, accessories, and inserts included
with pressure washer.
2.
Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
3.
Remove pressure washer from carton.
Carton Contents
Items in the carton include:
• Main Unit
• Safety Goggles
• Handle
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Oil Bottle
• Parts Bag (which includes the following):
Owner's Manual
Engine Manual
Owner's Registration Card
Bag containing 4 multi–colored Quick Connect Nozzles
Handle Fastening Hardware Kit (which includes):
Carriage Bolts (2)
Plastic Knobs (2)
"L" Bolts (2)
Lock Nuts (2)
SpeedClean™ 2800 PSI Pressure Washer
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-743-4115. If calling for
assistance, please have the model, revision, and serial
number from the data tag available.
Perform these tasks to prepare unit for operation:
1.
Fill out and send in registration card.
2.
Attach handle to main unit.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect high pressure hose to spray gun and pump.
6.
Connect water supply to pump.
7.
Attach nozzle extension to spray gun.
8.
Select/attach quick connect spray tip to nozzle
extension.
Attach Handle to Unit
NOTE: All assembly operations given in this section will
be described from the perspective of assembling the
pressure washer from the rear.
1.
Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
6
Align Holes
Handle
Handle
Supports

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido