Tabla de contenido
Publicidad
When mincing fruits, remove the pit and/or any tough
rind
For cleaning, we recommend using warm water only,
limiting the use of detergents. In this case, rinse the part
profusely. Do not immerse the motor unit in water or
other liquids; clean it with a damp cloth.
Caution: blades are very sharp; pay attention not to
cut yourself while removing the attachment or during
cleaning operations.
DESCRIPTION TR15
1. Working and PULSE button
4. Lid
7. Antislip feet
OPERATING THE UNIT
Assembling the unit by following the steps as shown besides.
1) Fit glass container properly into main body by turning it anticlockwise into place until it snaps.
2) Insert the rostrum in the container without touching the blades.
3) Insert the food without exceeding the maximum capacity.
4) Fit the lid properly over the container, by turning counterclockwise until it clicks in position.
5) Plug the unit and push the operation button to turn it on.
SAFETY BLOCK
This model has a double safety device: the unit only works if the container (3) is placed correctly into the
main body (6) and the lid (4) is correctly inserted in the joint (8). Remove the lid and the motor stops running.
In this case replace the lid.
FIRST USE
Removing and assembling the glass container a few times without plugging it or adding any fruits or
vegetables. Follow this step to practice with the appliance. Wash the lid and the jug with warm water and
dishwashing liquid. Other accessories made of electrical parts, such as the motor block and the main body
must be cleaned with a damp cloth and dry immediately.
GRINDING
The blade set consists of two blades that can chop and shred fruits, vegetables and meat; by adding liquids,
it's easy to prepare baby meals and homogenized food.
For a correct use follow the next steps:
- Pre-chop fruits and vegetables in small pieces and put them inside the container.
- If you want to prepare baby food or homogenized, add some water or milk not exceeding the maximum
capacity of the glass. Close the lid.
- Push and hold the power button until you reach the desired consistency of the food. At the end of the
process, power off the device and unplug it.
- Remove the container from the main body by gently pulling it up then pour the contents.
The PULSE button can be switched on for a machining pulse.
This food processor is not suitable for crushing ice, frozen foods, cereals, rice and coffee; these operations
2. Container slot
5. Rostrum with blades
8. Lid slot
3. Transparent container
6. Main body
9. Shaft
11
Publicidad
Tabla de contenido
