Maxx Ice ILLUMINATED Serie Manual De Instrucciones, Instalación Y Mantenimiento página 6

Part 2:
4. Rotate brackets at back of ice storage bin up and align them with the holes at bottom of ice-making unit
(Fig. 6). Secure brackets in place with provided screws (Fig.7).
5. Apply silicone caulk as necessary between ice maker and ice storage bin to form a water tight seal.
6. Place ice maker and ice storage bin in its final location.
7. Ensure the setup is level by using a carpenter's level or similar tool and rotating the adjustable legs (Fig. 8).
NOTE: Make sure the drain line water flow is not compromised, including appropriate slope to fully evacuate
the line as the ice melts water is discharged from the bin. Any crimp or possible blockage in the drain line may
cause water to back up into the bin, causing a health hazard and cause the stored ice to melt more rapidly.
Fig. 8
Ice Storage Bin
Fig.6
Module
Ice Maker
Gasket Seal
Brackets (loose)
Brackets (fastened)
90º
6
Ice Storage Bin
Fig.7