Preparation; Installing The Hanging Bracket - Hinkley 52 PROPEL ILLUMINATED Manual De Instrucciones

PREPARATION

PREPARATION:
Verify you have all parts before beginning the
installation. Check foam insert closely for
missing parts. Remove motor from packing. To
avoid damage to finish, assemble motor on
soft padded surface or use the original foam
inset in motor box.
DO NOT LAY MOTOR HOUSING ON ITS SIDE
AS THIS COULD RESULT IN SHIFTING OF
MOTOR IN DECORATIVE ENCLOSURE.

INSTALLING THE HANGING BRACKET

CAUTION: To avoid possible electrical shock, be sure electricity is turned off at
the main power box before wiring. All wiring must be in accordance with
National and Local Electrical Codes and the ceiling fan must be grounded as
a precaution against possible electric shock.
Locate ceiling joist where fan is to be mounted, being sure location
1
agrees with the requirements in the minimum clearance section of
this guide. Wood joist must be sound and of adequate size to
support 35 lbs. (See Page 1, Items 3 and 4).
If not already present, mount a UL listed outlet box marked "suitable
2
for fan support" following the instructions provided with the outlet
box. The outlet box must be able to support a minimum of 35
pounds.
Attach hanger bracket to outlet box using screws provided with the
3
outlet box.
Downrod
Blade
Motor Housing
Pull Chain with Fob
Parts identification on assembled fan.
Flat Washer
Spring Washer
Canopy
Blade Arm
Ceiling Fan
Outlet Box
Hanger
Bracket
Outlet Box
Screw
Fig. 1
©2019 Hinkley Lighting, Inc.
| hinkley.com | 05