Testing Your Fan - Craftmade Wyman WC42-3 Guia De Instalacion

9. Light Kit Assembly. (cont.)
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter. Connect BLUE
(or BLACK) wire from switch housing to BLACK
wire from light kit fitter. Be sure molex
connections snap together completely.
Align holes in light kit fitter with holes in switch
housing. Attach light kit fitter with screws that
were removed on previous page. Securely
tighten all 3 screws with a Phillips screwdriver.
Raise a glass shade to one of the sockets,
pushing up gently until lip on glass shade fits
securely inside socket. Attach glass shade to
light kit fitter with thumbscrews provided in one
of the hardware packs. [NOTE: Do NOT
overtighten thumbscrews as glass may crack or
break.] Repeat for remaining glass shades.
Install 3 candelabra base 60 watt max. bulbs
(included).
IMPORTANT: When replacing bulbs, please
allow bulb(s) and glass shade(s) to cool down
before touching.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with the pull chain on the switch housing. Start at
the OFF position (no blade movement). First pull will
set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth
pull will again set the fan to the OFF setting. Test
lights with the pull chain in the middle. (diagram 1)
If fan and/or lights do (does) not function, please
refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in your
comfort.
IMPORTANT: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extensions supplied or custom
pull chain extensions (sold separately) to ends of
the pull chains.
motor housing
reverse switch
molex
connections
socket
thumb-
screws
glass
shade
bulb
diagram 1
diagram 2
page 8
switch
housing
pull chain
extension
(for fan)
light kit fitter
thumbscrew
pull chain
extension
(for light)
diagram 3 diagram 4