Installation; Positioning Of Lights; Positioning Of Side Lights (Port And Starboard); Positioning Of All-Round Lights - Tranberg TEF 2880 Manual De Usuario

TEF 2880 NAVIGATION LIGHT -

INSTALLATION

Positioning of lights

Inboard screen is not required as the light itself fulfill the
requirements. If an inboard screen is installed please
follow the following procedure:
• Ref. COLREG 72, Annex I.

Positioning of side lights (port and starboard)

• COLREG 72, Annex I, 5: The sidelights shall be fitted
with inboard screens painted matt black, and meeting
the requirements of Section 9 of this Annex.
Not required
Cable bend radius + 50mm (min.)

Positioning of all-round lights

• COLREG 72, Annex I, 9(b): All-round lights shall be
so located as not to be obscured by masts, topmasts
or structures within angular sectors of more than 6
degrees, except anchor lights, which need not be
placed at an impracticable height above the hull.

Zero signal direction

• Zero signal direction is denoted on all sector lights
(e.g. "masthead" and "port") with an arrow. For
correct installation, this arrow shall point parallel
to the ships centre line. It should be pointing in the
same direction as the light distribution. It can be both
backwards and forwards depending on the sector of
the navigation light. Ref. figure 1.

Mechanical installation

See figure 1 & 2.

Fixing

• The navigation light shall be fixed to a plane horizontal
surface, by 4x M8 bolts. Maximum torque: 8 Nm. Ref.
figure 2 & figure 3.

Cable entries

• Direction of cable entries; see figure 1. Ensure enough
space to route cable and terminate cable properly.
Minimum space requirement: Cables bending radius
+ 50 mm.
INSTALLATION AND USER MANUAL
Paint inboard screen matt black.
Figure 3
Bolt, M8
Plain washer, M8
(Required and
included in shipment.)
Mounting foot
Locking nut M8, or nut + locking washer
2°
±1°
Page 7