Storage - Oreck DutchTech DTX 1200A Guia Del Usuario

R Motor F
eplacing
R E
eplacing xhaust
ADVANCED HEPA FILTER INSTALLATION:
E N G
ilter
Unplug unit from wall
outlet. Remove the dustbag
and carrier to access the
motor filter grill.
Using the tab located at
top of filter grill, lift filter
grill out of unit.
Remove filter from grill and
replace with new filter.
Change the motor filter
every fifth dustbag
replacement.
F
ilter
Unplug unit from wall
outlet. Remove exhaust grill
from back of unit by
pressing down and pulling
out on the tab located at
the top of the grill.
Discard used exhaust filter.
Place new filter in grill. Set
grill tabs in slots. Press top
of grill to snap closed. The
exhaust filter should be
changed with every fifth
dustbag replacement.
Note: Exhaust filter not
needed if Advanced Hepa
Filter is used.
Remove exhaust grill.
L I S H
S
8
Install Advanced Hepa Filter
by aligning tabs in slots and
pressing top to snap closed.
Note: Replace Hepa Filter
once a year or every fifth
dust bag replacement.
torage
Turn unit off and unplug
cord from outlet. Rewind
cord by pressing cord
rewind pedal. Do not allow
plug to whip when
rewinding.
When storing with
standard nozzle, stand
vacuum cleaner on end.
Insert friction wand clip
into slot located on base of
vacuum.
When storing with power
nozzle, the power nozzle
assembly connected or
disconnected will stand in
an upright position.