Warranty Information Read Before Beginning Assembly DHP warrants this product to be free from defects in material and workmanship and agrees to remedy any such defect. This warranty covers one year from the date of original purchase. This is solely limited to the repair or replacement of defective 2 (however it is always better parts and assembly labor is not included.
Página 4
CENTER SUPPORT LEG SIDE RAIL 1 SIDE RAIL 2 SIDE RAIL 3 CENTER RAIL 1 T926660 T926670 T926680 T926690 T926700 CENTER RAIL 2 CROSS BRACE SIDE SUPPORT LEG CORNER BRACKET WOODEN SLATS T393110 T926710 T927040 T926730 T926770 X 24 4027139...
Página 5
Before you throw the package, please use the Check Box to identify the parts and ensure that you have all the parts needed for the assembly. LEFT BRACKET RIGHT BRACKET SINGLE SLAT CAP DOUBLE SLAT CAP T393080 T393090 T927950 T926370 T926380 X 24 X 12 4027139...
1/4" X 1 3/8" 1/4" X 1 9/16" X 28 1/4" X 1 3/4" 5/16" X 2 1/4" 1/4" Hardware Note: Please do not completely tighten all the hardware, until the entire assembly is complete, unless indicated otherwise in the step-by-step instructions. 4027139...
Página 7
Step 1 Join (C) & (D) using (F) & (H) with BOLTS 3, as shown below. NOTE: Holes on part (F) should be facing upward. X 16 4027139...
Página 8
Step 2 Attach (G) to subassembly (C,D) from STEP ONE using BOLTS 3. X 12 4027139...
Página 9
Step 3 Attach (S1) & (T1) to subassembly from previous step using BOLT 1, as shown below. X 12 4027139...
Página 10
Step 4 Stick (A1) to the back of (A) with Velcro, as shown below. 4027139...
Página 11
Step 5 Pre-asssembly BOLT 1 to (A) & (B), then hang (S1) & (T1) onto BOLT 1. Please do not completely tighten Bolts (1) until Step 10 is complete. 4027139...
Página 12
Step 6 Push NUT 6 into the hole of the Leg Z, then attach (Z) to (N) with BOLT 5 and NUT 6. 4027139...
Página 13
Step 7 7.1 Attach (N X4) to (A)&(B)&(C)&(D) with BOLT 1; 7.2 Attach (L X2) to (H) with BOLT 2 . 4027139...
Página 14
Step 8 Insert (I) & (J) into (M) and secure using BOLT 1 as shown below. 4027139...
Página 15
Step 9 Attach subassembly (I,J) to (A) & (B) with B0LT 1 as shown below. 4027139...
Página 16
Step 10 Attach (K) to (F) & (J) with BOLTS 4 and NUTS 9, as shown. Completely tighten all bolts in this step. 4027139...
Página 17
Step 11 11.1 Insert (P) into (X); 11.2 Then press (X) into (F/G); 11.3 Repeat the same procedure for the opposite side as shown. 11.3 4027139...
Página 18
Step 12 Insert both (P) into (Y), then press (Y) into (I/J) as shown. 4027139...
Do not allow horseplay on the bed and prohibit jumping on the bed. D o not use substitute parts. Contact DHP for replacement parts. T he use of water or sleep flotation mattresses is prohibited.
Página 20
1-800-267-1739 / Lunes - Viernes / 9:00 am - 5:00 pm (hora del este) DHP / 410E, First Street South, Wright City MO 63390, USA Nota: El producto debe ser registrado dentro del mismo cuatrimestre en que se realiza la compra. Visite www.dhpfurniture.com/eng/register para mas detalles acerca de este concurso.
(Z) PATA:T927950 (X) Cubierta cuadrada - un orificio:T926370 (Y) Cubierta cuadrada - doble orificio: T926380 Paquete de componentes Paquete de componentes #: T4028319-01 Nota: Por favor no apriete completamente las piezas hasta que el las indicaciones paso a paso. 4027139...
(N) en (A) (B) (C) y (D) (L) en (H) con le CAMA. NO UTILICE PIEZAS SUSTITUTAS. ENTRE EN CONTACTO CON DHP PARA LAS Paso 8 PIEZAS DE REEMPLAZO. Una la parte "I" y "J" a la parte "M" con perno (1) , como se muestra a GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA.
Página 23
DHP. cs@dhpfurniture.com 1-800-267-1739 / Lundi - Vendredi / 9:00 am - 5:00 pm (Heure de l'Est) DHP / 410E, First Street South, Wright City MO 63390, USA Remarque: Attention: Consumer Service. concours.
LONG ET 53 1/2 " - 54 1/2 " AU LOIN. NE JOUEZ PAS SUR OU SOUS LE LIT ET NE SAUTEZ PAS SUR LE LIT. ci-dessous. L'UTILISATION DE MATELAS D'EAU OU DE MATELAS FLATTANT EST STRICTEMENT INTERDITE. ci-dessous. 4027139...