Publicidad
Enlaces rápidos
R I G I
PRESSURE BALANCE SHOWER SET
SET DE DUCHA DE PRESIÓN BALANCEADA RIGI
SKU: 948667, 948674
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing plumbing �xtures. Signature
Hardware accepts no liability for any damage to the
plumbing, shower, wall, or for personal injury during
installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping
damage. If any damage is found, contact our
Customer Relations team at 1-800-221-3379.
ANTES DE COMENZAR
Le recomendamos que consulte a un profesional si no
sabe cómo instalar accesorios de plomería. Signature
Hardware no asume ninguna responsabilidad con
respecto a los daños causados a la plomería, la ducha,
la pared, ni por daños personales que ocurran durante
la instalación.
Cumpla con todas las normas locales de plomería y
construcción.
Retire el producto del empaque y verifique si se
produjeron daños durante el envío. Si encuentra algún
daño, comuníquese con nuestro equipo de Servicio al
cliente al 1-800-221-3379.
GETTING STARTED
Ensure that you have gathered all the required
materials that are needed for the installation.
CÓMO COMENZAR
Asegúrese de haber reunido todos los materiales
necesarios para la instalación.
TOOLS AND MATERIALS:
HERRAMIENTAS Y MATERIALES:
Adjustable Wrench
Llave Ajustable
Safety Glasses
Gafas de seguridad
Neutral Cure
Silicone Sealant
Sellador de silicona
de curado neutro
Thermometer
Termómetro
1
Flathead
Phillips
Screwdriver
Screwdriver
Destornillador de
Destornillador
cabeza plana
Phillips
Keyhole Saw
Tape Measure
Sierra de punta
Cinta métrica
Groove Joint Plier
Plumbers Tape
Pinzas ajustable
Cinta Selladora
Para Rosca
Strap Wrench
Llave de correa
REVISED 01/29/2021
CODES: SHRI8020G, SH4001, SHRI8030G
1.800.221.3379
Publicidad
Manuales relacionados para Signature Hardware RIGI 948667
Resumen de contenidos para Signature Hardware RIGI 948667
- Página 1 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 BEFORE YOU BEGIN TOOLS AND MATERIALS: We recommend consulting a professional if you are HERRAMIENTAS Y MATERIALES: unfamiliar with installing plumbing �xtures. Signature Hardware accepts no liability for any damage to the plumbing, shower, wall, or for personal injury during installation.
- Página 2 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 Copper (Soldering)/ Cobre (Soldar) If you are replacing your plumbing valve, please review the common plumbing methods illustrated below (Copper, IPS). Remove the existing handle and valve trim before replacing your valve.
-
Página 3: Valve Installation
R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 VALVE INSTALLATION 3a. Thin Wall Installation: Are usually built up with materials such as �berglass tub surrounds and will be INSTALACIÓN DE LA VÁLVULA the main source of support for the valve. - Página 4 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 6. With Tub Outlet: Wrap plumbers’ tape around the 4. Remove the plaster guard (1) from the body (2). pipe threads in a clockwise direction. Connect the hot and cold water supply lines (1), the shower outlet pipe 4.
- Página 5 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 7. With No Tub Outlet: Wrap plumbers’ tape around 8. If the hot and cold inlets are reversed (hot on right and cold on left), remove bonnet (1) from the valve the pipe threads in a clockwise direction.
- Página 6 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 9. Use two 1/2" iron pipe plugs to seal both shower 10. Turn on water allowing water to �ow from tub outlet and tub spout outlet. Turn cartridge stem outlet or shower outlet without tub spout until all counterclockwise to full on mixed position.
- Página 7 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 12. Before adjusting the temperature, remove the 13. Rotate the lever counterclockwise until the water plastic cap (1) from the valve body (2) by twisting the is to the maximum desired temperature, not to cap in a clockwise direction.
- Página 8 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 14. Removing the limit stop ring, remember the 15. For colder water, adjust the limit stop ring (1) in a position of the limit stop ring (1) on the cartridge clockwise direction and reinstall the limit stop ring (1) assembly (2).
-
Página 9: Instalación
R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 INSTALLATION 16. If faucet leaks from spout, shut o� the water supplies and replace the cartridge (1). INSTALACIÓN 1. Screw nut (1) onto thread section of valve body. Note: Install cartridge (1) correctly for proper handle Insert the brass stem extension (2) to valve body. - Página 10 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 3. Insert the long end of the shower arm (2) through 4. Install tub spout. Push back tub spout �ange (1), the �ange (1), and wrap plumbers’ tape around the press tub spout (2) onto pipe until spout is properly long end of the shower arm (2) in a clockwise direction, positoned and tighten set screw (3) with Allen wrench...
- Página 11 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 5a. Flushing For Shower Only: Turn on hot and cold water supply lines allowing water to �ow from shower outlet (1) until all foreign matter has cleared the line.
- Página 12 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 Part Name / Nombre de pieza Part No. 2.5mm Hex Allen Wrench / 2.5mm Hex Llave Allen OBPF1RP70221 OBPF713416* Handle / Llave Escutcheon / Placa Ornamental OBPF380486* Screw / Tornillo...
- Página 13 R I G I PRESSURE BALANCE SHOWER SET SET DE DUCHA DE PRESIÓN BALANCEADA RIGI SKU: 948667, 948674 Part Name / Nombre de pieza Part No. Plaster Guard / Protector de yeso ACF4001GRD Cartridge / Cartucho ACF4001UCRT Stop Valve / Válvula con graduacione ACF4001STOP 1.800.221.3379...