Yamaha NS-B20 Manual De Instrucciones
Ocultar thumbs Ver también para NS-B20:

Publicidad

Idiomas disponibles

Idiomas disponibles

RL
NS-P20
(NS-B20 + NS-C20 + NS-SW20)
SPEAKER PACKAGE
OWNER'S MANUAL
MANUAL DE INSTRUCCIONES

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Resumen de contenidos para Yamaha NS-B20

  • Página 1 NS-P20 (NS-B20 + NS-C20 + NS-SW20) SPEAKER PACKAGE OWNER'S MANUAL MANUAL DE INSTRUCCIONES...
  • Página 2 Precautions Please read the following operating precautions before use. Yamaha will not be held responsible for any damage and/or injury caused by not following the cautions below. 1. To assure the finest performance, please read this 1. Do not operate this unit upside down. It may overheat, manual carefully.
  • Página 3 Precautions • VOLTAGE SELECTOR (For China, Korea, Asia and General models) The voltage selector switch on the rear panel of this unit must be set to your local main voltage BE- FORE plugging this unit into the AC main supply. Voltages are 110-120/220-240 V AC, 50/60 Hz.
  • Página 4: Tabla De Contenido

    Troubleshooting ..........5 Specifications............6 Package contents Make sure the package contains the following items. Front and surround Subwoofer speakers (NS-B20) x4 (NS-SW20) x1 Subwoofer cable 5 m (16 ft.) x1 Center speaker (NS-C20) x1 Speaker cable 25 m (82 ft.) x1...
  • Página 5: Installing The Speakers

    150 mm NS-C20 (5-7/8") Warnings • NS-B20 speaker weighs 0.48 kg (1.06 lbs.) and NS-C20 speaker weighs 0.68 kg (1.50 lbs.). Do not mount the speakers on thin plywood or on a wall with a soft surface material. Otherwise, the screws...
  • Página 6: Connecting The Speakers

    Connecting the speakers Caution: Make sure the power cables for the subwoofer and your other AV components are disconnected from the AC wall outlets before making any connections. Connection diagram Surround speakers Right Left Center speaker SPEAKERS FRONT SURROUND CENTER Amplifier ANTENNA (BD/DVD)
  • Página 7: Connecting The Power Cables

    (or “S”) for all of the NS-P20 speakers. Release the tab so that it closes securely on the If you’re connecting the subwoofer to a Yamaha DSP bare wire, not the insulation. amplifier or AV receiver, connect to its SUBWOOFER or LOW PASS output.
  • Página 8: Troubleshooting

    Notes • If you replace the front speakers (NS-B20) with other speakers, you will need to re-adjust the • Once the subwoofer volume has been set, you can subwoofer’s volume. leave the subwoofer’s VOLUME control set as it is and use your amplifier’s volume control to adjust the volume of the entire system.
  • Página 9: Specifications

    Dimensions (W x H x D) (10-3/8" x 10-3/8" x 11-3/4") NS-B20 ..115 x 176 x 88 mm (4-1/2" x 6-7/8" x 3-1/2") NS-C20.....291 x 101 x 103 mm (11-1/2" x 4" x 4") Weight .............. 7.0 kg (15.4 lbs.) Weight NS-B20 ............
  • Página 10 Precauciones Lea las siguientes precauciones de funcionamiento antes de iniciar el uso del aparato. Yamaha no se responsabilizará de cualquier daño o lesión causada por no seguir las precauciones que aparecen a continuación. 1. Para asegurar el mejor rendimiento posible, lea con 4.
  • Página 11 Solucionar problemas ........5 Especificaciones..........6 Contenido del paquete Compruebe que el paquete contiene los siguientes elementos. Altavoces frontales y surround Subwoofer (NS-B20) x4 (NS-SW20) x1 Cable del subwoofer 5 m x1 Altavoz central (NS-C20) x1 Cable del altavoz 25 m x1...
  • Página 12: Instalar Los Altavoces

    Mínimo 20 mm NS-C20 150 mm Advertencias • El altavoz NS-B20 pesa 0,48 kg y el altavoz NS-C20 Nota: Aquí, las ondas pesa 0,68 kg. No instale los altavoces en estacionarias pueden contrachapados de madera fina ni en paredes poco dificultar la audición...
  • Página 13: Conectar Los Altavoces

    Conectar los altavoces Precaución: Antes de realizar las conexiones, compruebe que los cables de alimentación para el subwoofer y los otros componentes AV no estén conectados a las tomas de CA. Diagrama de conexión Altavoces Surround Derecho Izquierdo Altavoz central SPEAKERS FRONT SURROUND...
  • Página 14: Conectar Los Cables De Alimentación

    Si conecta el subwoofer a un amplificador DSP de Yamaha o a un receptor AV, conéctelo a su Compruebe que la conexión sea segura SUBWOOFER o a la salida LOW PASS.
  • Página 15: Solucionar Problemas

    Yamaha autorizado. ■ Altavoces frontales, surround (NS-B20), y central (NS-C20)
  • Página 16: Especificaciones

    Impedancia................6 Ω 10 kΩ Respuesta de frecuencia Respuesta de frecuencia........30 Hz–160 Hz NS-B20 ..........70 Hz–25 kHz (–10 dB) Sensibilidad de entrada..INPUT (jack de patilla 1P RCA): –45 kHz (–30 dB) 80 mV (50 Hz, 50 W/5 Ω) NS-C20..........

Este manual también es adecuado para:

Ns-c20Ns-sw20

Tabla de contenido