Pre-Installation Information - Bradley S19-788 Manual De Instrucciones

S19-788, S19-788LHS
Read this installation manual completely to ensure proper installation, then file it with the
Installation
owner or maintenance department. Compliance and conformity to drain requirements and
other local codes and ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted for before discarding
Packing List
•
• any packaging material. If any parts are missing, do not begin installation until you obtain
•
T H IS
•
E
S ID
U P
the missing parts.
The inspection and testing results of this equipment should be recorded weekly to verify
proper operation. This equipment should be inspected annually to ensure compliance with
ANSI Z358.1.
Workers who may come in contact with potentially hazardous materials should be trained
regarding the placement and proper operation of emergency equipment per ANSI Z358.1.
P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA
TEL: 1-800-BRADLEY FAX: (262-251-5817)
http://www.bradleycorp.com
114-051
For questions regarding the operation or installation of this product, visit www.bradleycorp.
com or call 1-800-BRADLEY.
Product warranties and service parts information may also be found under "Products" on our
web site at www.bradleycorp.com.
100˚ F
This unit is to be used with tepid, potable water as defined by ANSI Z358.1. (Note: avoid
60˚ F prolonged exposure to ambient heat sources above 100° F, or below 60° F).
Failure to lift unit by the provided handles may damage unit.
NOTICE! Avoid cleaners containing organic solvents, alcohols, and hydrocarbons.
Rinse with water after cleaning.
Supplies Required:
• Pipe sealant
• Air pressure equipment or supply (clean and free of oil and contaminants) capable of up to 100 psi .
• Sign-mounting hardware
• Adjustable Wrench
2
IMPORTANT
7/29/2014
Bradley • 215-550 Rev. S; ECN 14-05-015
Installation