Automatic Operation - Zibro S1825 Instrucciones De Uso

OFF. If both operations are set, it will show TIMER ON-OFF which indicates you have chosen to set both
the starting time and off time.
FAN SPEED Indicator:
Press the FAN SPEED button to select the desired fan speed setting (Auto-Low-Med-High). Your selecti-
on will be displayed in the LCD window except the Auto fan speed.
NOTE!
All items are shown in the Fig.2 for the purpose of clear presentation But during the actual
operation only the relative functional items are shown on the display panel.
Operating the Remote Controller
Install / Replace Batteries
Use two dry alkaline batteries (AAA/LR03).
Do not use rechargeable batteries.
1. Remove the battery cover on the back of the Remote Control by pulling it according to the arrow
direction shown on the cover.
2. Insert new batteries making sure that the (+) and (-) of battery are installed correctly.
3. Reattach the cover by sliding it back into position.
NOTE!
• When replacing batteries, do not use old batteries or a different type battery. This may cause
the remote controller to malfunction.
• If you do not use the remote controller for several weeks remove the batteries. Otherwise
battery leakage may damage the remote controller.
• The average battery life under normal use is about 6 months.
• Replace the batteries when there is no answering beep from the indoor unit or if the
Transmission Indicator light fails to appear.
• Never mix new and old batteries. Never use different battery types (e.g. alkaline and
manganese dioxide) simultaneously.

AUTOMATIC Operation

When the Air Conditioner is ready for use, switch on the power and the OPERATION indicator lamp on the
display panel of the indoor unit starts flashing.
1. Use the Mode select button to select AUTO.
2. Push the or button to set the desired room temperature. The most comfortable temperature set-
tings are between 21ºC to 28ºC.
3. Push the On/off button to start the air conditioner. The OPERATION lamp on the display panel of the
indoor unit lights. The operating mode is AUTO. The FAN SPEED is automatically controlled.
4. Push the On/off button again to stop the unit operation.
NOTE!
• In the AUTO mode, the air conditioner can logically choose the mode COOL, FAN, HEAT and
DRY by sensing the difference between the actual ambient room temperature and the set
temperature on the remote controller.
• If the AUTO mode is not comfortable for you , the desired mode can be selected manually.
4
110