Sylvania LD370SS8 M2 Manual De Instrucciones página 38

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

O
PERATING DVD
Stereo Sound Mode
Stereo Sound Mode
CD
VCD
This unit allows you to select a sound mode during CD playback.
During playback, press [AUDIO] repeatedly until the
desired sound mode appears.
Each time you press [AUDIO], the sound mode
changes as example below.
STEREO (stereo sound with left and
L-ch
R-ch
Note:
Virtual surround cannot be changed when the sound mode
is set to either "L-ch" or "R-ch".
Virtual Surround
Virtual Surround
DVD
CD
You can enjoy virtual surround on your existing 2 channel stereo system.
1
During playback, press [MODE] repeatedly until "
appears.
2
Press [ENTER] to select the sound level.
1 :
Natural effect.
2 :
Emphasized effect.
OFF : No effects (original sound).
3
Press [BACK/RETURN] to exit.
Note:
The setting will be kept even if the unit is turned off.
For audio CD and video CD, virtual surround will not be
effective if the sound mode is set to something other than
"STEREO".
Refer to "Stereo Sound Mode".
Turn down the level or select "OFF" if the sound is distorted.
38
EN
STEREO
right channels)
(left channel sound only)
(right channel sound only)
VCD
MP3
OFF
1
Marker Setup
Marker Setup
DVD
CD
This feature allows you to assign a specific point on a disc to be called back later.
To set a marker
1
During playback, press [SEARCH MODE] repeatedly
until "
" appears.
2
Use [Cursor s / B] to select an available marker within
30 seconds.
3
When the playback reaches the point at which you
want to set a marker, press [ENTER].
Marker is now set.
4
Press [BACK/RETURN] to exit.
"
To return to the marker later
1
To select a desired marker, repeat steps 1-2 in
"To set a marker".
2
Press [ENTER] at the desired marker to restart playback
from the specific point which you set.
Note:
Marker search menu will disappear in about 30 seconds
when there is no input.
You can mark up to 10 points.
To clear a marker, select the marker to be cleared at step 2 in
the section "To set a marker" or
"To return to the marker later", and then press [CLEAR].
Ejecting the disc or turning off the power will erase all
markers.
Selecting "
" at step 2 in the section "To set a marker" or
"To return to the marker later" will also erase all markers.
VCD
w/o PBC
e.g.) DVD
e.g.) DVD

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido