Install The Hardware; Access The Video Stream - Axis P1355 Guia De Instalacion

AXIS P1355/P1357 Installation Guide
Dimensions
Model
AXIS P1355
AXIS P1357

Install the hardware

!
IMPORTANT! - AXIS P1355/P1357 is designed for indoor and outdoor use. To use the
camera outdoors, it must be installed in an approved outdoor housing. Please see
www.axis.com for more information on outdoor housings.
Connect the cables
1. Connect external input/output devices if required, such as alarm devices. See page 10 for
information on the terminal connector pins.
2. Connect an active speaker and/or external microphone if required.
3. Connect the camera to the network using a shielded network cable.
4. Connect power, using one of the methods listed below:
• PoE (Power over Ethernet). PoE is automatically detected when the network cable is
connected.
• Connect an external power adapter to the power connector block; see Unit connectors,
on page 10 for wiring information.
5. Check that the indicator LEDs indicate the correct conditions. See the table on page 13 for
more details. Note that the Status LED can be configured to be unlit during normal operation.

Access the Video Stream

Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup
H x W x D
46 x 78 x 205 mm (1.8" x 3.1" x 8.1")
46 x 78 x 205 mm (1.8" x 3.1" x 8.1")
Weight
600 g (1.32 lb)
600 g (1.32 lb)
Page 7