Maintenance Instructions - Paoli HURRICANE Manual De Instrucciones

MAINTENANCE INSTRUCTIONS

Before any maintenance, always make
sure that the air supply of the wheel gun
is depressurized (no air pressure), and
only after unplugging the wheel gun and
performing maintenance.
L Use only recommended lubricants.
L Every 20-30 cycles it is recommended to fill
(special oil for Paoli air impact wrench motors
or very fluid oil for air tools) the oil tank, by
loosening (use a 14 mm hexagonal key) the
oiler block in the bottom side of the wheel
gun; then tighten again the oiler block
figure Fig.2-A). The oil tank capacity is ~ 8 cc.
These operations alow to keep the appliance
efficient and to extend its service life.
L Setting the oiler: to change the setting,
unscrew the locknut
English key (view figure
screw or unscrew the shutter
screwdriver (view figure
a smaller or greater flow. After adjustment,
tighten locknut 1 to lock the setting.
L Ship the wheel gun back to the PAOLI
facilities at least once per year for the
complete overhauling.
L Do not carry out maintenance with improper
tools, make use of the attached exploded
drawing with the list of spare parts.
SCRAPPING
Separate the components on the basis of the nature of the materials of which they are made. The
components must be disposed of according to the laws in force.
ENGLISH
8
OPERATING AND MAINTENANCE MANUAL
(view
1 with a 10 mm hexagon
Fig.2-A) and then
2 with a cutting
Fig.2-A) to obtain
L Indicate the parts most subject to wear,
to be dismantled and checked at regular
intervals, as well as a list of malfunctions,
if any, and the corrective action.
L Use only genuine spare parts and
authorized service organizations.
L Before every
recommended to run the wheel gun
clockwise and anticlockwise (please pay
attention to the exhaust coming out
from the top of the wheel gun during
this operation -
putting special oil for Paoli air impact
wrench motors (~5cc) or very fluid oil
for air tools into the air inlet. These
operations must be performed in a
suitably equipped working environment,
complete with extraction equipment
for nebulised particles. Use personal
protective equipment.
L If the wheel gun is left unused for
long periods we recommend putting
some oil (special oil for Paoli air impact
wrench motors) into the air inlet
figure Fig.2-I) and letting it run for a few
seconds before putting it away. In this
way the internal components will remain
lubricated.
race it is strongly
view figure Fig.2-B)
(view