Rear Panel - Marq COLORMAX PAR64 Guia Del Usuario

Features

Rear Panel

1. Power In: Use a standard power cable (included) to connect this input to a power outlet.
2. Fuse: This compartment holds the fuse. Before cleaning or replacing the fuse, disconnect
Colormax PAR64 from its power source. Use a screwdriver or other tool to remove the
compartment (do not pull it out by the tab only). Replace the fuse only with a new fuse with the
same rating (125 V, 1 A).
3. Power Out: Use a standard power cable to connect this output to an additional fixture. This
connection will supply power to the additional fixture when this one is connected a power outlet.
Please see Setup > Linking > Power
Note: On models sold in the USA, this will be a standard "Edison" (NEMA) connection. On other
models, this will be a standard IEC connection.
4. DMX In: Use a standard 3-pin DMX cable to connect this input (A) to your DMX controller or (B)
to another fixture that will pass DMX data through it to this one. Colormax PAR64 receives DMX
data over this connection. Please see
multiple fixtures.
5. DMX Out: Use a standard 3-pin DMX cable to connect this output to an additional fixture.
Colormax PAR64 sends its data to an additional fixture over this connection. Please see
Linking > DMX
6. Display: This display shows messages and values indicating the fixture's current status.
7. Menu: Press this button to access Colormax PAR64's menu.
8. Up/: Press this button to select the next-highest menu option or to increase the value by 1.
9. Down/: Press this button to select the next-lowest menu option or to decrease the value by 1.
10. Enter: Press this to confirm your current selection or value.
4
5
4
for information about linking multiple fixtures.
2
6
7
10
8
9
for information about linking multiple fixtures.
Setup > Linking > DMX
1
3
for information about linking
Setup >