Perel TC76204 Manual Del Usuario página 5

Mounting Instructions
1. Remove the M6x20 screw [1] from the heater.
2. Fix the bracket [2] on the heater with the M6x20
screw [1].
3. Drill two holes (Ø 8 x 40 mm) at a distance of
55 mm. Install the hanger [4] on the wall using
two M6x60 expansion bolts [3].
4. Fix the heater on the hanger and fasten using the
M8x60 bolt [5] and M8 nut [5b].
5. Adjust the tilting angle. Loosen the M8 nut,
adjust the angle to the desired position, and
tighten the nut.
V. 03 – 25/09/2017
TC76204
5 ©Velleman nv