Use - AEMC Instruments 2118.75 Manual De Instrucciones

„ connect the two spring loaded 10a test probes to the four terminals of the instrument.
„ loosen the nuts on the binding posts, insert the spaded lugs, being very careful to connect the red
leads to the voltage terminals (P), then tighten the nut.
„ if the instrument has safety terminals, unscrew the spaded lugs to make the connection.
„ place the voltage probes (identified by red spots) as close as possible to one another.
„ during the measurement, hold the test probes firmly in contact with the object being measured.
For details of the measurement configuration, technical specifications and error messages, refer
to the user manuals of the 6240 or 6250.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

2. USE

6
TestEquipmentDepot.com
C
1
P
1
P
2
C
2
C
1
P
1
P
2
C
2