Publicidad
Idiomas disponibles
Idiomas disponibles
ADDiTiONAL THINGS YOU SHOULD KNOW
Now that you understand
the basic operation
functions,
here are mare control features
with which you should became
familiar.
The "coot
circuit has an automatic
3 minute time delayed
start if the unit is turned off and on quicHy. This prevents
overheating
of the compressor
and passible
circuit breaker
tripping.
The fan will continue to run during
this time.
There is a 2-Second
delay
for the compressor
shutting down when selecting
FAN ONLY. This is to cover the possibility
of having
to roll through to select another
mode.
The control will maintain
the set temperature
within 2 degrees
Fahrenheit,
between
60F and 90F degrees.
If the unit is turned off in heat made (if applicable)
or fan only mode, it will return to the same setting when it is turned
on again.
When the unit is turned off in cool or energy
saver mode, it will run in energy
saver made when it is turned
on again,
but
the setting of temperature
and fan speed will remain.
Models
with a key hole overflow
drain hole can use drain kit 5304481680
to connect a 1/2 inch drain hose for safe
disposal
of excess system water. This part can be ordered
at www.SearsPartsDirect.com.
The control is capable
of displaying
temperature
in degrees
Fahrenheit
or degrees
Celsius. To convert
from one to the
other and back, press and hold bath the "TEMP/TIMER"
Up(A)
and Dawn (v)
buttons for 3 seconds.
FAULTCODES :
If the display
reads "ES" or "AS", a sensor has failed.
Contact
1-800-4-MY-HOME®
for repair.
AUTO RE-START :
ID
Evaporator
coil sensor
g
Air temperature
sensor
After
a power outage,
the unit will remember
the last setting and return the unit to the same setting once power is restored.
FRESHAIR VENT CONTROL
1. Pushed In (Fig. 1) - Recirculates
inside air
2. Partially
Pulled Out (Fig. 2) - Draws fresh air into room
3. Fully Pulled Out (Fig. 3) -
Exhausts air from room and draws fresh air into room
Figure 1 ( VENT CLOSED
Figure 2 ( VENT OPEN )
Figure 3 ( VENT & EXHAUST OPEN )
Publicidad
