Bimar HI-PET HC01P Folleto De Instrucciones página 13

Fax +32 030 9904733

•
The dog: The dog's hair should be freshly washed and dried, and all knots and tangles
brushed out. Before you start clipping, turn the clipper on and hold it near the dog to
familiarise the dog to the humming sound of the clipper.
•
The style: Familiarise yourself with your dog's breed standard: how its coat should
look like and how to get it looking this way. A lot of information is available on the
internet.The style: Familiarise yourself with your dog's breed standard: how its coat
should look like and how to get it looking this way. A lot of information is available on
the internet. The groomer (yourself): Make sure you know how to trim your dog's
coat safely before you start clipping. If you have not clipped your dog before, obtain as
much information aspossible beforehand. Observe a professional groomer, vet or
trainer while they are clipping your/a dog. Ask questions so you know what to expect.
Then, try to be as relaxed as possible.
•
Turn the clipper off frequently during clipping and touch the blades to make sure the
blades are not getting too warm — hot blades can burn your dog! While using the unit,
untwist the cord from time to time to avoid tanglingDuring clipping, take care not to
cut into loose skin. Always ensure you hold the clipper with the blade running parallel
to the skin.It is normal that the pet clipper becomes hot during use. However, take care
not to burn your dog with hot blades. To prevent the blades becoming too hot, switch
off the unit regularly during clipping, take off the guide comb and apply a few drops of
oil to the blades. Wipe off any excess and start again.
•
Do not use water to cool the blades! Oiling the blades regularly during use will also
keep them cleaner, which means they will cut better.
MAINTENANCE
Important: before performing routine cleaning, remove the plug from the mains and wait
for the device to cool. The clipper set requires careful cleaning after each use.
•
Check the alignment and lubrication of the blades before use. For proper operation of
the device, frequent lubrication of the blades is required (12).
•
The blades must be aligned after each cleaning or replacement.
To align the blades: the space between the ends of the upper
blade teeth and the lower blade teeth should be 0.8 mm, as
shown in the figure.
•
Change the blades when they are no longer sharp.
•
Use the small brush supplied to clean the blades of the clippers.
•
Wash the brush and comb using the small brush supplied using warm water and
household washing up liquid. Then rinse with plenty of water, and dry thoroughly.
•
Do not use abrasive or aggressive products or substances such as petrol or acetone to
clean the device.
•
For long periods of time, you should stow the clippers and its accessories away from
dust and moisture; we recommend using the original case provided.
•
If you decide to no longer use the device, it is recommended that it is made inoperative
by cutting the power cable (first ensure that the appliance has been unplugged from the
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
13 40
/
Assembly page 13/40