Uniteck UNIDETECT 5.24 Manual Del Usuario página 10

EN
WIRING (CONTINUED)
 Finalize the assembly
STAGE AREA SETTINGS
The system will perform an automatic 30-second test. During the test, the connected instrument remains
on. When it turns off, a range test starts. Now, in the event of movement, the device will activate for
about 5 seconds, regardless of the ambient light level (at each movement, the luminaire will turn on again
for 5 seconds). Once you have made this setting, you can make further settings.
Activate mode

If your motion detector is connected to a switch, make sure it is in the ON position.
 Positioning :
- The LUX button on the sun symbol
- The TIME button on 10s
 Align the motion detector as desired.
10/19
www.uniteck.fr