Package Contents; Safety Information - Whalen LWS48DCVAG Instrucciones De Montaje

PACKAGE COnTEnTS

C
A
B
D
E
D
HARDWARE COnTEnTS (not shown actual size)
AA BB
Touch-up Pen Bolt Lock Washer
Qty. 1 Qty. 8+1 extra Qty. 8+1 extra

SAFETY InFORMATIOn

Please read and understand this entire manual before attempting to assemble or install the product.
WARnInG
Do not stand on vanity. Use vanity on level ground. Base
vanity supports a maximum weight of 200 lbs. Exceeding
maximum weight limit will compromise the integrity of the
vanity structure and could cause the vanity to fail.
CAUTIOn
Do not hang from the vanity.
PREPARATIOn
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware
contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 15 minutes
Tools Required (not included): Silicone compound.
PART DESCRIPTIOn
A Vanity Top (preassembled)
B Vanity Base
C Backsplash
D Vanity Feet
E Support Leg
D
CC DD EE
Flat Washer Wood Dowel
Qty. 8+1 extra Qty. 8+1 extra
Maximum load 200 lb. (90.7 kg)
Maximum load 10 lb. (4.5 kg)
Maximum load 30 lb. (13.6 kg)
Maximum load 30 lb. (13.6 kg)
Maximum load 30 lb. (13.6 kg)
2
ASSEMBLY InSTRUCTIOnS
Step 1: Vanity Feet Installation
QUAnTITY
1a. Insert wood dowel (EE) into vanity feet (D).
1b. Attach vanity foot (D) to the vanity base (B) by inserting the bolts (BB)
1
through lock washers (CC) and flat washers (DD). Tighten with hex
1
wrench (FF).
1 1c. Attach Suppot Leg (E) to bottom of Vanity Base (B) and screw the
pre-assembled bolt into place.
4
1
Hardware Used
BB Bolt
CC
Lock Washer
DD
Flat Washer
FF
EE
Wood Dowel
EE
Hex Wrench
Hex Wrench
Qty. 1
Step 2: Adjustable Level
2a. In case of uneven floors, floor levelers are provided at the bottom of the
vanity. If necessary, adjust floor levelers by hand to correct tilting and/or
level doors.
Step 3: Backsplash Installation
3a. To mount the backsplash (C) to the wall, apply a thin bead of silicone
compound (not included) to the unpolished back side and bottom of the
backsplash (C). Position backsplash (C) as shown onto vanity top (A)
and against the wall. Clean any excess silicone compound before
allowing to dry.
1
EE
B
E
DD
x 8
x 8
x 8
2
x 8
x 1
3
C
3
DD
D
CC
CC
BB
Silicone
A