Tabla de contenido
Publicidad
3.
Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT: Pilot holes must be drilled to a depth of 2¾ in. (70 mm). Be sure to drill into the center of the studs.
4.
Install wall plate
using four lag bolts
12
CAUTION:
Avoid potential personal injury or property damage! All lag bolts
of the wall plate
. Ensure the wall plate is securely fastened to the wall before continuing on to the next step.
12
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
Go to STEP 3 on PAGE 14.
3
and four washers
. Tighten the lag bolts only until they are pulled firmly against the wall plate.
13
14
2 ¾ in. (70 mm)
7/32 in.
(5.5 mm)
MUST BE firmly tightened to prevent unwanted movement
13
4
12
14
13
11
Publicidad
Tabla de contenido
