Brandson Equipment 304994 Manual Del Usuario página 33

• Clean the outside of the appliance with a soft, slightly moist cloth. Use a
mild dish washing detergent if necessary.
NOTE: Do not use any organic solvents, boiling water, cleaning agents, strong
acids and bases, etc., for cleaning.
• Please empty the water tank and dry it for storage if the ice maker is not
used for long durations.
8. Troubleshooting
Error
"ADD WATER" LED
lights up
"FULL ICE" LED
lights up
Ice cubes are
sticking to each
other
The ice-making
process seems to
run as usual, but
no ice is produced
English
Cause
• Low water level
• Sensor is blocked
• Pump is faulty
• Ice collector is full
and the light barrier is
blocked
• Light barrier is faulty
• Water temperature is
too low
• Water temperature is
too high
• Ambient temperature
is too high
• Cooling system is not
working
Troubleshooting
• Fill the water tank
• Clean the sensor
• Please contact our customer
service department
• Empty the collector
• Check the light barrier
• Fill the water tank with water
at a temperature of between
8°C and 25°C
• Fill the water tank with water
at a temperature of between
8°C and 25°C
• Make sure that you operate
the appliance only in an am-
bient temperature between
10°C and 32°C
• Please contact our Customer
service department
33