English - LevelOne PLI-4251 Guía De Instalación Rápida

English

Hardware Installation
Ethernet Cable (RJ-45)
Powerline
Notebook
Front Panel LEDs
PWR Normal Operation
The Powerline network is active.
This means that at least one
PL
other HomePlug Device was
detected.
1~4
Ethernet connection is active
Configuration requires the use of Windows PC. Once configured, any device may be connected to the 500Mbps
HomePlug AV Adapter's Ethernet port. To perform configuration, follow the procedures list below.
1. Connect a RJ-45 Ethernet cable from the 500Mbps HomePlug AV Adapter's Ethernet port to your PC.
2. Connect a RJ-45 Ethernet cable from your xDSL/Cable Modem's Ethernet port to the other Powerline Ethernet
Adapter's LAN Ports.
3. Plug the500Mbps HomePlug AV Adapter into a power outlet.
4. Wait a few seconds for start-up to be completed, and then check the LEDs.
PWR

The LED should be ON.
PL

The LED will be ON if other HomePlug devices are detected, otherwise it will be OFF.
1~4

The LED should be ON
Room 1
PC
On Flash
NA
- Data is being transmitted or
received via the Powerline
network.
Data is being transmitted or
received via the Ethernet Port.
- 4 -
Room 2
ADSL / Cable Modem
Powerline network is not available
- no other HomePlug devices were
No Ethernet connection
Internet
Off
No Power
detected.