PNI VX6000 Guia De Inicio Rapido

PNI VX6000 microphone with VOX function
Technical specifications
• Impedance: 1000 Ohms
• Frequency: 3KHz
• Connector: 6 pins
• Power supply: 12V (through the 6 pin socket)
• VOX sensitivity levels: 4
• VOX Delay levels: 4
• Background noise reduction
• Dimensions: 55 x 30 x 78 mm
• Operating temperature: -26° ~ +60°C
Pins diagram
PIN 1 - Modulation
PIN 2 - RX
PIN 3 - TX
PIN 4 - Non used
PIN 5 - Ground (GND)
PIN 6 - Power supply +12V
VOX sensitivity adjustment
Long press the ▲ key to enter the VOX sensitivity setting mode. The microphone will emit a long beep
1.
and the red LED will light up.
Briefly press the ▲ key to move to the next sensitivity level. There are 4 levels. The level of sensitivity
2.
is indicated by the number of beeps emitted by the microphone, accompanied by as many flashes of
the red LED. For example, if you set level 3, you will hear 3 beeps and the red LED will flash 3 times.
3. Press the PTT key to confirm.
Note: The most sensitive level is level 1 and the least sensitive is level 4. We recommend setting the microphone to
level 1.
Setting VOX Delay
Vox Delay is the time between the end of the signal and the end of the VOX transmission.
1. Long press the ▼ key to enter the VOX Delay level setting mode. The microphone will emit a long beep
and the red LED will light up.
Briefly press the ▼ key to move to the next level. There are 4 levels. The delay level is indicated by the
2.
number of beeps emitted by the microphone, accompanied by as many flashes of the red LED. For
example, if you set level 3, you will hear 3 beeps and the red LED will flash 3 times.
3. Press the PTT key to confirm.
Note: The shortest delay time is on level 1.
User manual 1