Tabla de contenido
Publicidad
FSE FITTING SQUARING MACHINE
SECTION V
A.
Shoe Selection and Installation / Removal
1. Select shoe set, reference selection chart on pg.
8
2. Slide shoes into open end of shoe slot. Shoe with
one threaded hole installed first ( Figure 1).
Figure 1
3. Install retaining block. Secure screws with 5/32"
allen key.
4. To remove shoe, loosen screws. Slide shoe set
out.
B.
Workpiece Clamping Procedure
1. Retract clamping knob by turning counter clock-
wise.
2. Slide workpiece through shoe set. Do not dam-
age tool if installed.
3. Tighten clamping knob. Turn clockwise until
workpiece is held firmly.
4. Remove workpiece by turning clamp knob counter-
clockwise.
FSE SETUP & OPERATING PROCEDURES
C.
Tool Bit Installation
CAUTION: Unplug machine from power
source before installing or changing
tool bits.
1. Place tool bit into tool slot. Position for desired work
dia. Check tool bit alignment with end of tube. Tool
should be as far from center as possible (Figure 2).
CUTTING
PORTION
Figure 2
2.
Tension screws with 1/8" allen key.
D.
Drive Motors for the FSE 1.0
1. Motors for FSE: Milwaukee and Metabo. Milwau-
kee has simple variable speed trigger. Metabo has
variable speed trigger, "ON" position lock, dial speed
control; electronic load sensing speed stabilization.
E.
Machining Instructions
1. Begin rotation. Squeeze trigger to obtain desired
speed.
2. Feed is controlled by rotating feed knob. (Fig. 3 )
3. Index marks on feed knob indicate tool advance.
9
(CONT.)
TUBE
Publicidad
Tabla de contenido
