Hummer H-214RGB Manual De Instrucciones página 5

Intel installation
1) Attach the LGA 115X
metal clips onto heatsink
base.
Intel installation
1) Attach the LGA 2011 / 2) Apply the thermal
2066 metal clips onto paste on CPU
heatsink base.
Connecting the fan
Motherboard RGB control
B) If your motherboard has any RGB
lighting system, plug the RGB Hub
adapter into the motherboard and
make sure the pin with an arrow
is connected to the 12 V pin on
motherboard.
LGA 115X
2) Put the backplate 3) Apply the thermal
onto the back of paste on CPU
motherboard.
LGA 2011 / 2066
3) Put the heatsink
onto the processor
and hook the
vertical clip.
A) Connect the fan connector to the RGB Hub adapter.
Internal RGB controller
C) If your motherboard doesnt has
any RGB lighting system, plug the
RGB hub adapter into the internal
RGB controller in the way showed
in the picture above. Then connect
the Internal RGB controller to a PSU
connector.
4) Put the heatsink
onto the processor
and hook the vertical
clip.
AMD installation
1) Attach the AMD metal 2) Apply the thermal
clips onto heatsink base. paste on CPU
Internal RGB controller features:
MODE:
Press this button to switch the lighting into a dynamic mode.
- Blinking mode: 7 color cycle / Green / Blue / Red / Cyan / Lime
/ Purple / White
- Breathing mode: 7 color cycle / RGB cycle / Green / Blue / Red /
Cyan / Lime / Purple / White
COLOR:
Press this button to switch the lighting into a static mode. There a lot
of different colors for choice.
SPEED/BRIGHT:
- When the lighting is running in dynamic mode, this button will
change the speed of the ligthing effect.
- When the lighting is running in static mode, this button will control
the brightness of the light.
- Hold this button to turn off the LED lighting. Press it again to turn
on the lighting.
FM2 / FM1 / AM3+ / AM2+ / AM2 / AM4
3) Put the heatsink
onto the processor
and hook the
vertical clip.