Greenlee 2007 POWER FINDER Manual De Instrucciones página 7

The green POWER LED will glow. (If it doesn't, remove and
replace the 9 volt battery, which is accessed by sliding the small
battery door on the rear of the receiver to the open position).
Continue to move the GAIN knob in the clockwise direction until
it has reached its maximum travel. Move the receiver to within a
few inches of the transmitter. All 4 red LEDs will intermittently
glow, and the unit will emit a beeping sound. The 2007 is now
ready to operate.
3) Take the receiver to the vicinity of the suspected power source
for the circuit being tested. If a signal is received, move the
receiver toward the equipment, producing the increase in signal
strength. (The receiver will pick up a signal within 12 to 18
inches of a panel, even with the panel cover closed).
4) If the signal is present, open the door, position the RANGE
switch to LOW and move the receiver slowly down the row of
breakers or fuses as shown below.
NOTE: The receiver
must be held in the
position shown here to
be properly aligned
with the magnetic field
produced by the
transmitter and provide
maximum performance.
Greenlee Textron Inc. / Subsidiary of Textron Inc.
2007 POWER FINDER™ Circuit Tracer
4455 Boeing Dr., Rockford, IL 61109-2988 USA 815/397-7070
7