Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Power Dome
™
• DO NOT charge more than 16 hours through the DC outlet.
• After charging the battery, disconnect the adapter from the accessory
socket first, then from the charging jack.
• Replace the dust cover on the charging jack.
DC TO AC POWER INVERTER
The Power Dome's inverter can operate most AC appliances or a combination of
appliances up to 200 watts. Operating time is dependant on the AC load (watts)
and the charge and condition of Power Dome's internal battery. Reduced AC loads
and a full charge on the battery will result in longer operating time. Be sure to turn
off or disconnect any AC appliance not in use. There is a user replaceable 25 amp
automotive type fuse below the inverter ON/OFF switch. This fuse protects the
inverter from an unlikely excessive power draw or short circuit. Ordinary overloads
will cause the inverter to automatically shut down. Reduce the load and restart the
inverter.
USING THE POWER INVERTER
CAUTION: Some rechargeable devices are equipped with a separate AC charger.
These devices are likely to operate properly with this inverter. Rechargeable
devices that have built-in chargers, on the other hand, may not be compatible with
this type of inverter (see device owner's manual).
Some motorized devices may operate at excessively elevated temperature when
used with this inverter. During first use with this inverter, check for excessive motor
temperature. Abnormally elevated temperature of the device is an indication that
they should not be used with this inverter.
1. Open the AC outlet dust cover.
2. Connect the AC appliance or appliances to either AC outlet.
3. Turn on the inverter by switching the Inverter's ON/OFF switch to the ON
"|" position.
4. If the Inverter Power Indicator LED light is green, the inverter is operating.
5. Turn on one AC appliance and observe the Power Indicator.
• If the LED remains green, then turn on the second appliance.
• If the Power Indicator remains green, then both
appliances are operating properly.
• If the Power indicator LED is not lit, then reduce the AC load. If the
inverter is still not operating, refer to the troubleshooting table at
the end of this User's Manual.
6. After use, remove the appliances from the plugs.
5
NX by Wagan Tech
www.wagan.com
®
Publicidad
Tabla de contenido
