Adax NEO H Manual Del Usuario página 7

Thermostat Userguide Adax WT2
Thermostat layout
1. Display - shows the desired temperature
2. Red light - Lights when the heater is warming
3. Blue light - Wi-Fi indicator - lights up when
the heater is installed and connected
4. "ok" for activating different functions
(see explanation in the manual)
5. Increases the desired temperature
6. Decrease the desired temperature
Switch the heater on / off with the button
on the right side of the heater.
This Adax WiFi thermostat is intended for remote control via the Adax WiFi App.
The product can also be used without App connection as follow (manual use):
Main features for manual use
1. Set the desired temperature with the 5 (+) or 6 (-) buttons on the thermostat.
2. Key lock / child lock. The thermostat can be protected from unwanted use that children
and others cannot change settings. This function is turned on / off by holding the 5 (+) and 6 (-)
button for 5 seconds until CC flashes in the display, repeat the process to turn key lock off.
3. Turn display light on / off. This function is turned on / off by holding the 6 (-) and 4 (ok) buttons
for 5 seconds til display flashes 3 times. The display will turn off 30 seconds after adjustment and
will be lit again by pressing any button (+, - or ok).
4. To enable programs (schedule program, anti frost, etc.), the heaters must be installed
and controlled via the Adax WiFi app.
Control the heater with Adax WiFi App on your mobile.
1. Download "Adax WiFi" for Apple in App Store or for Android in Google Play.
2. Follow the instructions in the App for installation.
3. When the heater is installed, all the heater functions are controlled via the App.
To learn more about features and options for the app, please visit www.adax.no/wi-fi
Tips and additional features.
1. Reset to factory settings - Hold "+" and "ok" inside until the display quickly flashes
"rESET" and then goes to 20 degrees.
2. In case of power outage, the heater will start to heat at the last recorded temperature
when power is back.
3. When the heater is connected to the app, child protection is activated via the App
and not manually on the thermostat.
4. Turn on / off display light. This function is turned on / off by holding the 6 (-) and 4 (ok) buttons
for 5 seconds. The light (s) will turn off after 30 seconds and will be lit again by
pressing any button (+, - or ok).
EN
2020-03-10 art.no.: 62008
Wi-Fi 2,4 GHz, WPA2, 802.11 b/g/n + Bluetooth
iPhone (IOS 10.0 or higher)
Android 5.0 og higher
7