Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WArNING:
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings,
brushes, commutators, etc. Consequently, we do not recommended using this tool for extended work on these
types of materials. However, if you do work with any of these materials, it is extremely important to clean the tool
using compressed air.
REPLACING SOLDERING TIP
WArNING:
before removing the tip. Touching a hot soldering tip can result in serious personal
injury.
NOTE
: Only use ZGLSI08B-PT point tip or ZGLSI08B-CT chisel tip as the replacement tips.
• Remove the battery pack from the tool.
• Turn the soldering tip counter-clockwise to remove the old tip. use a pair of pliers if needed.
• Install a new tip by screwing it on clockwise. Do not over-tighten.
TWO-YEAr WArrANTY
This product is warranted free from defects in material and workmanship for 2 years after date of purchase. This
limited warranty does not cover normal wear and tear or damage from neglect or accident. The original purchaser
is covered by this warranty and it is not transferable. Prior to returning your tool to store location of purchase,
please call Toll-Free Help Line for possible solutions.
THIS PRODUCT IS NOT WARRANTED IF USED FOR INDUSTRIAL OR COMMERCIAL PURPOSES.
ACCESSORIES INCLUDED IN THIS KIT ARE NOT COVERED BY THE 2 YEAR WARRANTY.
BATTERY INCLUDED IS WARRANTED FOR ONE (1) YEAR AFTER DATE OF PURCHASE.
TOLL-FrEE HELP LINE
For questions about this or any other GeNeSIS Product, please call Toll-Free:
www.genesispowertools.com
Or visit our web site:
©richpower Industries, Inc. All rights reserved
Richpower Industries, Inc.
736 Hampton Road
Williamston, SC 29697
Do not at any time let brake fluids, gasoline, petroleum-based
Always allow the soldering tip to cool for a minimum of 30 minutes
888-552-8665
.
9
Publicidad
Tabla de contenido
