Manhattan 178150 Instrucciones página 4

Initial Setup / Built-in Battery Charging
Prior to initial use as a wireless headset, the built-in battery needs to be charged. A full
charge can take up to 3 hours, but you can listen to music or make phone calls while
charging.
1
Use the included USB-to-micro USB cable to connect the headset (G) to a powered
computer or other charging device.
2
The red LED (F) lights while charging; the blue LED (F) lights when the charge is
complete. Note: The red LED flashes twice to indicate low voltage. Recharge the battery
as soon as you can.
Bluetooth Pairing & Operation
This product utilizes the latest in Bluetooth wireless technology; wireless performance
may vary from device to device. If using this product with a Mac or PC, ensure that your
Bluetooth driver is up to date. If it isn't, visit your computer manufacturer's website for
details and updates.
1
Press the Multifunction button (A) for about 7 seconds, until the LEDs (F) alternately
flash red and blue. Note: Pressing the Multifunction button for just 3 seconds will put
the headset in Standby mode (the blue LED flashes).
2
With the headset LEDs (F) alternately flashing red and blue, activate your device's
Bluetooth function and search for Bluetooth devices. Refer as needed to the manual of
your phone, tablet, computer, etc. regarding its Bluetooth operation.
3
Once the device finds "manhattanFUSION" an on-screen prompt will ask if you're ready
for pairing. Click or press OK or Confirm to continue. Note: If the device prompts you
to enter a PIN, enter 0000 and click or press Yes or Confirm to continue.
• After a successful connection is made, the blue LED (F) will flash and the headset will
beep. If the pairing has failed and the LEDs are still alternately flashing red and blue, the
pairing procedure needs to be re-initiated on your source device.
• This headset can connect with two types of devices: those using a Hands-Free or Headset
Profile (HFP or HSP), such as smartphones; and those using an Advanced Audio
Distribution or Audio/Video Remote Control Profile (A2DP or AVRCP), such as laptops.
• Every time the headset is turned on, it will automatically connect to the last connected
device.
Power on / Standby* Press the Multifunction button (A) about 3 seconds. The blue LED (F) flashes.
Power off* Press the Multifunction button (A) about 5 seconds. Both the red and the blue LEDs (F)
flash with an audio confirmation.
Pairing* Press the Multifunction button (A) about 7 seconds (until the LEDs alternately flash red
and blue).
Answer/End a call* Briefly press the Multifunction button (A).
Last number redial In Standby mode, press the Multifunction button (A) twice.
Play/Pause Press the Multifunction button (A) to play or pause music.
Press + (D) or – (E) to increase or decrease the volume.
Volume up/down
Previous Briefly press
Next Briefly press
Voice dial In Standby mode, press the Multifunction button (A) and listen for the beep that indicates
you can start to voice dial. (Not all phones feature this option.)
* with voice prompt
4
ENGLISH
Quick Reference Guide
<
(C) to play the previous song in a playlist.
>
(B) to play the next song in a playlist.