Zamel exta free ROP-02 Manual De Instrucciones página 8

SWITCH ON/SWITCH OFF mode (two push-buttons):
Press PROG push-button of ROP-02 device for a longer time until LED red diode switch-
es on (constant signal). Next release PROG push-button.
pushbutton. LED red diode switches on (first signal pulsates, next the signal is constant).
Press and release the second transmitter's push-button. LED red diode switches on (the
signal pulsates) and next it switches off - THE TRANSMITTER IS ADDED.
TIME MODE (one push-button):
Press PROG push-button of ROP-02 device for a longer time till LED red diode switches
on (constant signal). Next release PROG push-button.
pushbutton. LED red diode switches on (the signal pulsates, next the signal is constant).
Press and release the same transmitter's push-button. LED red diode switches on (the
signal pulsates) and next it switches off - THE TRANSMITTER IS ADDED.
An exemplary programming procedure. The procedure for the rest of radio EXTA FREE
transmitters is analogous. CAUTION: Every transmitter can cooperate with ROP-02 in
a different mode, depending on how they were added to the device. One transmitter
can be added during one programming cycle. Full memory is signalled with pulsating
LED red diode.
RADIO TRANSMITTERS POGRAMMING - CHANNEL 2
Press PROG push-button of ROP-02 device for a longer time till LED red diode switches
on (constant signal). Next release PROG push-button. Wait (for about 5 seconds) till LED
red diode switches on (first signal pulsates, next the signal is constant).
of five ROP-02 operating modes and programme the device in the same way as for channel
1. CAUTION: For the monostable mode, press the button on the remote before press-
ing PROG push-button.
RADIO TRANSMITTERS DELETION
Press PROG push-button of ROP-02 device for a longer time.
red diode switches on (signal pulsates) and then it switches off.
in ROP-02 - MEMORY IS DELETED.
TIME PROGRAMMING
Press PROG push-button of ROP-02 device for a longer time till LED red diode switch-
es on (constant signal). Next release PROG push-button. Wait (for about 5 seconds)
till LED red diode switches on (first signal pulsates, next the signal is constant).
again (for about 5 seconds) till LED red diode switches on (first signal pulsates, next the
signal is constant).
for CHANNEL 1:
red diode switches off and then switches on (signal pulsates). Every LED diode pulse
equals 1 second.
flashes) press PROG push-button and then release it - TIME IS ADDED.
for CHANNEL 2:
(first signal pulsates, next the signal is constant).
02 device and then release it. LED red diode switches off and then switches on (signal
pulsates). Every LED diode pulse equals 1 second.
(the number of LED red diode flashes) press PROG push-button and then release
it - TIME IS ADDED.
Maximum time is 18 hours for every channel.
Press PROG push-button of ROP-02 device and then release it. LED
After the adjusted time is finished (the number of LED red diode
Wait again (for about 5 seconds) till LED red diode switches on
Press and release transmitter's
Press and release transmitter's
After 5 seconds LED
Release the push-button
Press PROG push-button of ROP-
After the adjusted time is finished
Choose one out
Wait