Part Identification; Important - Premier ED-898 Manual De Instrucciones

PART IDENTIFICATION

IMPORTANT

Ensure that the voltage in the electrical network is the same as that on the type plate.
The iron should always be turned off before plugging or unplugging the power cord.
Never yank the cord while unplugging it from the outlet! Instead, grasp the plug and pull it to unplug.
Never use the appliance if it is damaged in anyway.
When leaving the iron, even when only a short while, always unplug the power cord.
Close supervision is necessary for any appliance being used by or near children.
Do not leave the iron unattended while connected or it is on the ironing board.
Burns can occur from touching hot metal parts, hot water or steam.
Be careful when you turn the steam iron upside down - there may be hot water in the reservoir.
Never immerse the iron in water.
Always place the iron with its back on a firm flat surface when interrupting ironing or after use.
Keep the soleplate smooth. Avoid hard contact with metal objects.
The cord should not be allowed to touch the soleplate when it is hot.
When using the iron for the first time, test on an old piece of fabric to ensure that the soleplate and water
tank are completely clean.
Your iron is designed to rest on its heel. Do not leave the iron unattended when switched on. Do not
place the iron on an unprotected surface even if it is on its heel rest.
Setting the Temperature
**Synthetics-silk
**Wool
**Cotton-linen
Stand the iron upright
Set temperature control to ironing temperature.
Plug in the power cord to the outlet.
After the indicator light has gone out and come on again, you may start ironing. The indicator light will go
out from time to time during ironing.
P-2