Safety Precautions - Drive Medical R800KD-RD Guia De Inicio Rapido

assembly instructions
Do not attempt to adjust or operate Rollator without
carefully reading all instructions in this manual.
1. Remove all contents from packaging: backrest, back
wheels (with brake handles), rollator frame with seat
and carry bag, front wheels. Included are six tightening
knobs and four c-clips for easy and secure assembly.
2: Unfold rollator frame and turn onto its side. Attach
wheels without brakes to the front of the rollator by
inserting the wheel into the corresponding tube
(Figure A). Align hole on wheel tube with frame and
secure in place using tightening knob A, threading the
knob on the inside (Figure B). Insert c-clip above knob
to secure wheel in place (Figure C). Repeat with
second wheel.
A B
3: Rotate the rollator frame. Attach the back wheels (with
brake handles) by inserting tube into the rollator
frame, making sure the wheels are facing the outside
of the rollator. Align hole on wheel tube with frame
and secure in place using the tightening knob,
threading the knob on the inside. Insert c-clip above
knob to secure wheel in place. Affix brake cable to the
"S" shaped clamp provided on the rollator frame.
Repeat with second wheel.
4: Position rollator upright. Insert the brake handle tube
into the frame and set to desired height. Secure in
place using tightening knob B, threading the knob in
from the outside. Repeat for second handle, making
sure both are set to the same height.
5: Attach padded backrest by depressing the black thumb
buttons and sliding into the black brackets. Note that
the back rest can be folded up when not in use.
WEIGHT CAPACITY 350 LBS (158 KG)
Adjustment Knobs
Folding Hinge
for Portability
Wheel Tightening
C
1. Please make sure the Rollator is fully opened, seat
is down and the folding bar under seat is locked in the
down position.
2. Be sure that both knobs are fully tightened and are at
equal heights. Test Rollator for stability before
applying full weight to hand grips.
3. Test the loop locks before operating the Rollator.
When wheels are locked (see illustrations for locking
and releasing locks below), lock bar on rear wheels
should prevent wheels from rolling. If the wheels
roll while brakes are locked, please take unit back
to dealer for adjustment. When locks are released,
the wheels should roll freely.
4. Always lock loop locks before sitting and do not use
seat when unit is on an incline or uneven ground.
5. Replace tires when significantly worn or damaged.
Do not have anyone push you while you are seated on
the Rollator. This is a walking aid only and is not to be
used as a transportation device.
Loop Locks
Safest System
Available
Backrest
Height
Knob

safety precautions

Important Safety Notice
Orthodic
Hand Grips
Comfortable
Padded Seat
Hanging Bag
for Functionality
& Storage